GTFO Tool-kit sd_partial

GTFO Tool-kit sd_partialThe GTFO Tool Kit contains all the tools that you will need to VESC your GT and install the GTFO kit. The Kit Contains: 1x Torx TP45 6" Wrench (to unmount the GT Motor and mount the Superflux). 1x L wrench Tool to use different Bits with. Torx Bits to be used with the wrench above: TP25 Torx Plus Bit (To unbolt the fenders, footpads, bumpers, axle block cover) TP20S 5 point security bit (for opening the controller and battery). Hex Bit (2mm) to open

are covered under warranty for 1000 miles or 1 year

The female connector is included and pre-installed on the controller box

Compatible with most VESC boxes (just plug the M20 gland to any VESC box and connect XT60 to the VESC)

We took all the magic from the 6" Superflux

Typically no taxes or customs  are charged

Superflux Motor Connector

1x Suuuper-bright Front LED

This is required to connect the GT Footpads with the Thor300 VESC

Warranty is valid only for uncut sensors

The GT Footpad plugs directly into the 6-pin side

Fungineers charger is preferred but other GX-16 style chargers will fit in the charger port

(can achieve freespin of more than 100km/h with field weakening)