Bando P26H150 SD QD Timing Belt Pulley (SD) RPF6 (11mm wide)Bando P26H150 SD The type of pulley used on a Synchro Link drive depends on a number of factors, including but not limited to, space available, ratios, center distances, horsepower being transmitted, speeds and user preference of mounting systems (i. e. QD, TL or Minimum Plain Bore). With Synchro Link Drives, as with gear or chain drives, circular pitch (usually referred to as pitch) is a fundamental consideration. On the belt, pitch is the distance
25 MOUNTING STUD MOTOR TYPE FHP OPPOSITE END BEARING BALL SHAFT END BEARING BALL AMBIENT 70 ROTATION CCW LEAD END REV SERVICE FACTOR 1 RUNCAPMFD 7
Dual Voltage Lyall Plug
9 LB-FT Locked-Rotor Torque 23
Standard NEMA MG-1 Frequency 60 Hz Voltage 575 V Number of poles 4 Degree of Protection IP56 Synchronous speed 1800 rpm Output rating 10 HP Mounting F-1 Flange C Terminal box¹ Left position Enclosure IC411 - TEFC Electric Motors
Bando - 600-S14M-4326 HP Anticipating the demand for energy savings and higher horsepower transmission
83 LB-FT Pull-Up Torque 3
Nominal Outside Length (mm)3575
35 A Rated torque 2
5 VOLTS 110/220 AMPS 7
Bando - 60-S3M-306 Unique modified curvilinear tooth form enables the STS belt to transmit greater loads than like-sized drives having the standard high torque tooth profile
VENM3546T SPEC 35E016Z818G1 HP 1 VOLTS 230/460 AMPS 3
Frame 250S/M Output 55 kW (75 HP) Number of Poles 4 Frequency 50 Hz Rated speed 1480 rpm Slip 1
