Hall Effect Sensor Module relay

Hall Effect Sensor Module relayThe Hall Effect Sensor Magnet Detector Switch for Arduino is a switch that will turn on off in the presence of a magnetic field. If no magnetic field is present, the signal line of the sensor is HIGH (3. 5 V). If a magnetic field is presented to the sensor, the signal line goes LOW, at the same time the LED on the sensor lights up. An onboard LED will also indicate the presence of a magnetic field. Pin Connection Connect the Powerline (middle) to +5V

Total 60 Jumper wires set

to achieve inter-module combination

Out 2: Motor A lead out

A range of operation: 8 – 10 meter

30mm Axle(Small Axle) - 4

Big gear(1)

\nEmitter Base Voltage(VBE) is 5V

Plug-and-Play Compatibility :- All electronic blox included Acceleration Sensor

Salient Features of 4x18650 Battery Holder

\n Operating Current: 15mA

Small wheels(2)

\nLeisure and sports