C4 Fabrication Swing Arm Ham Antenna Bracket roof mounted light bar

C4 Fabrication Swing Arm Ham Antenna Bracket roof mounted light barPlease reach out for most accurate lead time Ham Antenna Bracket that bolts onto C4 rear bumper swing arms No drilling required Hardware included

1/4" steel mounting brackets and hitch

and cracking common with standard rubber seals

Made from 14 and 11 gauge steel

• Do NOT use tow/haul modes while unladen as the increased rear stiffness could upset the balance between the front and rear of the vehicle

these bedsides provide the necessary clearance for oversized tires and a wider stance

No cutting required

000 lbs Winch)

We took this into consideration when designing our new kit and the solution was to design a "pocket" in the lower arm that the outer CV can sit in thus allowing the arm to gain back the ground clearance typically lost on 4x4 IFS trucks

Ark Splash Guards are proudly made in America

If you are after the ultimate Tacoma IFS front end we recommend adding our lower control arm pivot kit

bacon and eggs

The HXB Optics feature dual axis control