Laser Temperature Non-Contact Thermometer Gun bfcm2023

Laser Temperature Non-Contact Thermometer Gun bfcm2023Great for measuring heat temperature output on flash cure units and conveyor dryers. It helps tremendously to determine proper curing temperatures to minimize drying mistakes. This temperature gun provides a great way to solve common temperature measurement problems and is small enough to fit in your pocket. The popular temperature gun also includes a single dot laser sighting to assist with aiming. Note: Do not use to measure body temperature.

Roll the film

This keeps the positive from peeling off on the film since the surface under the plastic carrier sheet is still semi-moist

Foil only sticks to plastisol

Butt-to-butt separations: This technique keeps the ink from blurring on sharp line color transitions and helps to avoid the urge to flash during the print cycle when using high mesh counts

Makes for an easy line up and registration alignment on both the screen and the press

This additional time at cure temperature increases an inks performance characteristics like stretch and abrasion resistance

Peel according to your transfer paper or film instructions

you can print foil adhesive or plastisol where you want the foil to transfer to and the rest of the design use water based or discharge inks

Your mistakes will be gone without a trace

Slightly viscous to improve cling to screen during application

Our green blockout pen is ultra-fast drying (30 to 90 seconds) and water-soluble

Ink should be removed from screen as soon as printing is completed