6'10" Jive Lifter face

6'10" Jive Lifter face6'10" x 20 3 4" x 2 3 4" *Fins Included Jacob Ells is a Santa Barbara based shaper who is always looking to push the boundaries of alternative boards. The Lifter is one of Jives newest models and one of Jacob's most intriguing. The outline's widepoint is set further back, with a winged thumb tail, and pulls in quickly at the nose. The rocker profile is very flat and the rails are very bladey. The bottom contour starts with a slight single in the nose

synthetic routine obsolete

When Christian's not shaping

narrow round tail

This is the perfect board for someone looking for a smaller board with a lot of volume as an alternative approach for gutless or poor surf

and cruise down the line with ease

The domed deck does a nice job of hiding a lot of volume through the center of the board and makes the rail thin and approachable

7'3" x 22 1/4" x 3 1/8"

The rocker of the board is relatively flat in the nose and steadily kicks up through the tail

The bottom contour exhibits a gently rolled hull entry that tapers into a rolled vee that reaches its apex just above the fin box before softening out towards the tail

6'4" x 22" 17 1/4" Nose 15 1/4" Tail x 3" (Fin included)

He grew up surfing this zone and has amazing memories of the wedging turquoise peaks Newport can produce

developed the Special K model for one of surfing's most notable displacement hull figures